Skip to main content
Lake County, Ohio - Utilities

Back Flow Prevention

    Back Flow Prev

    Link to Environmental Protection Agency (EPA) 

    Frequently Asked Questions:

    •  What is Backflow?

    The flow through a cross-connection from a possible source of contamination back into the drinking water system

    • What is Cross-Connection?

    Any physical connection between a possible source of contamination and any drinking water system piping

    • Why does Backflow occur?

    Backflow occurs when a cross-connection is created and pressure reverses, either as backsiphonage or backpressure, in the water supply piping

    • What are some common backflow hazards that threaten the homeowner and other consumers?

    Hose connections to chemical solution aspirators to feed lawn and shrub herbicides, pesticides or fertilizers

    Lawn irrigation systems

    Chemically treated heating systems

    Hose connections to water outlets or laundry tubs

    Swimming pools, hot tubs, or spas

    Private and/or non-potable water supplies located on the property

    Water-operated sump drain devices

    Feed lots/livestock holding areas or barnyards fed through pipes or hoses from your water supply plumbing

    • What can you do to prevent backflow situations in your home or business?

    Be aware of and eliminate cross-connections

    Maintain air gaps. Do not submerge hoses nor place them where they could become submerged

    Use hose bib vacuum breakers on fixtures (hose connections in the basement, laundry room and outside)

    Install approved, testable backflow prevention devices on lawn irrigation systems

    Do not create a connection between an auxiliary water system (well, cistern, or body of water) and the water supply plumbing

    • What must be done to protect the public water system?

    The water supplier is required to determine potential and actual hazards. If a hazard exists at a customer’s service connection to the public water system, the customer will be required to install and maintain an appropriate backflow prevention device at the meter and/or at the source of the hazard

    •  Who is responsible?

    In Ohio, the responsibility for preventing backflow is divided. In general, State and local plumbing inspectors have authority over plumbing systems within buildings, while the Ohio EPA and water suppliers regulate protection of the distribution system at each service connection

    Water customers are ultimately responsible for properly maintaining their plumbing systems and ensuring that cross-connections are not created, and that any required backflow prevention devices are tested yearly and are in operable condition

    Click here for a list of State Certified Backflow Testers

    • What is the law?

    Ohio Administrative Code Chapter 3745-95 requires the public water supplier to protect the public water system from cross-connections and prevent backflow situations. The public water supplier must conduct cross-connection control inspections of their water customer’s property to evaluate  cross-connection hazards

    • Why should you be concerned?

    All cross-connections pose potential health risks-including chemical burns, fires, explosions, poisonings, illness, and death

    Backflow can pose a health hazard if contaminated water enters your water supply plumbing system and is used for drinking, cooking or bathing

    Cross-connections with water supply plumbing or public drinking water piping systems are prohibited by law

    Protecting the public water system from backflow contamination is the law

    You are responsible for protecting your water supply plumbing from backflow that may contaminate your drinking water and the drinking water of others. This includes complying with plumbing code and not creating cross-connections